Journal of Clinical and Diagnostic Research, ISSN - 0973 - 709X

Users Online : 24537

Original article / research
Year : 2016 | Month : May | Volume : 10 | Issue : 5 | Page : ZC112 - ZC116

Influence of Custom Trays, Dual-Arch Passive, Flexed Trays and Viscosities of Elastomeric Impression Materials on Working Dies

Mansi Arora, Shivani Kohli, Rupali Kalsi

1. Private Practioner, (Prosthodontics), New Delhi, India. 2. Senior Lecturer, Department of Prosthodontics, MAHSA University, Kuala Lumpur, Malaysia. 3. Reader, Department of Periodontics, Shree Bankey Bihari Dental College, Ghaziabad, U.P, India.

Correspondence Address :
Dr. Mansi Arora,
72 C GH 10, Sunder Apartments, Paschim Vihar, New Delhi-110087, India.


Introduction: Dual arch impression technique signifies an essential improvement in fixed prosthodontics and has numerous benefits over conventional impression techniques. The accuracy of working dies fabricated from dual arch impression technique remains in question because there is little information available in the literature.

Aim: This study was conducted to compare the accuracy of working dies fabricated from impressions made from two different viscosities of impression materials using metal, plastic dual arch trays and custom made acrylic trays.

Materials and Methods: The study samples were grouped into two groups based on the viscosity of impression material used i.e. Group I (monophase), whereas Group II consisted of Dual Mix technique using a combination of light and heavy body material. These were further divided into three subgroups A, B and C depending on the type of impression tray used (metal dual arch tray, plastic dual arch tray and custom made tray). Measurements of the master cast were made using profile projector. Descriptive statistics like mean, Standard Deviation (SD) were calculated for all the groups. One way analysis of variance (ANOVA) was used for multiple group comparisons. A p-value of 0.05 or less was considered statistically significant.

Results: The gypsum dies obtained with the three types of impression trays using two groups of impression materials were smaller than the master models in dimensions.

Conclusion: The plastic dual arch trays produced dies which were the least accurate of the three groups. There was no significant difference in the die dimensions obtained using the two viscosities of impression materials.


Crown and bridge, Impression, Profile projector, Quadrant, Technique

How to cite this article :

Mansi Arora, Shivani Kohli, Rupali Kalsi. INFLUENCE OF CUSTOM TRAYS, DUAL-ARCH PASSIVE, FLEXED TRAYS AND VISCOSITIES OF ELASTOMERIC IMPRESSION MATERIALS ON WORKING DIES. Journal of Clinical and Diagnostic Research [serial online] 2016 May [cited: 2018 Jul 18 ]; 10:ZC112-ZC116. Available from

DOI and Others

DOI: 10.7860/JCDR/2016/16851.7840

Date of Submission: Sep 16, 2015
Date of Peer Review: Nov 21, 2015
Date of Acceptance: Feb 23, 2016
Date of Publishing: May 01, 2016


JCDR is now Monthly and more widely Indexed .
  • Emerging Sources Citation Index (Web of Science, thomsonreuters)
  • Index Copernicus ICV 2016: 132.37
  • Academic Search Complete Database
  • Directory of Open Access Journals (DOAJ)
  • EBSCOhost
  • Embase & EMbiology
  • Google Scholar
  • HINARI Access to Research in Health Programme
  • Indian Science Abstracts (ISA)
  • Journal seek Database
  • Google
  • Popline (reproductive health literature)